If you need a stationary pump to move loads of oil, then check out this monstrous industrial gear pump! It's designed specifically to suck up thick, heavy oils and spit them out the other end at 25 gallons per minute for hours on end.
It utilizes a heavy duty shaft coupler that's attached to your choice of a 3 phase
220/460 volt industrial electric motor or a single phase 120/220 volt industrial electric
motor. Both of which are rated at 3 HP and spin at 1800 rpm.
The stationalry pump consists of a body, baseplate, gear, bearing seat with safety valve, bearing, and seals. The body and bearing seat are made of cast iron. The gear is made of high grade carbon steal. Viton seals are standard.
How The Pump Works
Safety Relief Valve
The massive pump head features a 1.5" NPT opening with a pressure relief valve set at 48 psi. With it's 120 lb weight, it's ready for just about anything you can throw at it!
Single Phase Motor Specs (115/230 Volt)
Three Phase Motor Specs (208-230/460 Volt)
Ships direct from vendor
(1) 25 GPM Industrial Oil Gear Pump with 3 HP Single-Phase 120/220 Volt Motor
MGBJ Enterprises, LLC - 801-820-5753 - © Copyright 2005-2017 - All Rights Reserved - NX NEW